After the development of crushing machinery and equipment in China for half a century, the scope of use and the number of uses have increased by several degrees, and they also occupy a large number of commonly used machinery. After years of independent research and development, Guansheng Machinery Co., Ltd. has practiced and produced crushing machinery and equipment with advanced technology, high service life, high quality and low failure rate. However, due to the maintenance and maintenance of machinery by many operators 2. The operation skills are not too mastery, resulting in improper operation or irregular operation during the work process, causing serious damage to the machine and some failures that could have been avoided, so here is a guide for everyone to properly operate the crushing machine What misoperations should the equipment avoid to extend the service life of the machine.
A brief summary can be divided into three aspects. The first is to be careful not to drop the iron into it, the jaw will break or the shaft will break. This error is relatively low-level, and the harm caused is more serious, so it should be avoided as much as possible. And mainly deal with details, such as do not put some iron blocks on the crusher equipment and so on. Secondly, the bearing should be tested for temperature when the machine is stopped every day. If the temperature is too high, it should be filled with oil. In addition to oil lubrication to ensure its lubrication, it can also prevent the heat dissipation of the bearing when the oil is too little. Finally, periodically check whether the position of the pulley counterweight is on the same straight line. The most basic thing is to tighten the screws at intervals, especially for newly installed machinery and equipment.
In short, during the operation of the machine, the operator should be familiar with the practical knowledge of the machine. If it is not too clear, you can refer to the manual. If you encounter a difficult problem, you can also call the relevant technical specialist of Guansheng Machinery Factory, or log in to the relevant knowledge section of our official website http://ylscps.com to learn the relevant knowledge.