In a previous related article, there was a mention of a selection guide for the combination of a supercooler and a cooling tower. According to the past actual experience, a 1HP chiller requires a 1.2 ton cooling tower to take away the heat generated by the chiller, so This section will not explain too much about the cooling water tower. Under normal circumstances, when domestic vertical and horizontal injection molding machines are used at normal ambient temperature, the cooling water condensation temperature of the water-cooled chiller is below 35 degrees, (the condensation temperature of the air-cooled chiller is below 43 degrees) There are two kinds of matching methods at the time, and the two methods are analyzed in detail below:
The first way:
1hp water-cooled chiller can be equipped with 80 ton clamping force injection molding machine temperature control at 5-10 degrees;
1hp water-cooled chiller can be equipped with a 100-ton clamping force injection molding machine temperature control at 10-15 degrees;
1hp water-cooled chiller can be equipped with 120 ton clamping force injection molding machine temperature control at 15-20 degrees;
(The matching of the air-cooled chiller is 0.8 times that of the water-cooled chiller, that is, the 1HP air-cooled chiller can be equipped with a 64-ton clamping force and the temperature of the injection molding machine is controlled at 5-10 degrees)
The second way:
1HP water-cooled chiller can be equipped with an injection molding machine with a single injection volume of 10 QZ to control the temperature at 5-10 degrees.
The injection quantity 1QZ = 28.5g is the result summarized by Sutra. In addition to using the above formula, the salesperson should test the actual situation and select the appropriate chiller.
Although the above-mentioned matching method may not be too accurate, it is still very suitable in actual application, and it can also meet the requirements of the general situation!
Scan on WeChat